6v red indicators come with one of two different style retaining clips:

1) The star clip (not shown) must be slid over the wiring before the indicator is installed.

2) The e-clip can be installed (or removed) at any time. Recommended installation technique is shown at the right. The lamp must be firmly pressed into position against outside the front panel before the clip is installed. The clip must positioned against the inside of the chassis as shown before it is slid into position. Tape can be used to avoid scratching the inside of the chassis.

3) Important!   Twist the two leads around each other before installation, and use only the minimum length necessary to reach a source of 6V.   This will minimize audio hum and interference.

Copyright ©2024 Studio Sound Electronics - All Rights Reserved
Not responsible for web site errors or omissions.
  WARNING: These products may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov